Skip to content

Bathtubs Refinished: How to maintain their appearance

Refinishing a bathtub that is damaged instead of purchasing a new tub can be a cost effective option. Although bath tub reglazing covers rusty areas, chips and cracks, scratches or holes in the bathtub, as well as weak spots like the plumber's cuts, it is important to know how to maintain the tub once the process has been completed. Waiting 48 hours to use the bathtub after it has been refinished is essential. The bathtub surface can become damaged when the finish is not set Bathtub HQ.

The ledges should not be left with bottles of soap or bar soaps after the first waiting period has ended and the tub can again be used. The water can be trapped for a long time on the surface, causing the glaze to erode. You can purchase holders to hang inside the tub and shower. They will allow you to keep your shampoos and soaps close at hand without damaging the new bathtub finish. The bath mats, wet towel or rug that are usually hung above the tub can be another source of moisture.

Although it is vital to maintain the appearance of your tub, you should avoid using cleaners that contain abrasives on the freshly finished surface. Clean porcelain and fiberglass surfaces with non-abrasive gel, liquid or foam cleaners. Cleaning the tub regularly will prevent the accumulation of soapy scum. If there are no signs of dirt, regular cleaning will help remove the soapy film. A nylon net scrubber or soft plastic scrubber can be used to clean soap scum without damaging surfaces. A cheap, non-abrasive shampoo will remove any oily residue that may remain after reglazing the bath tub.

New finishes can sometimes make the bath slippery. Use a nonsuction bathmat if this is the case. The suction cups at the bottom of the mat can cause damage to the newly installed surface. They should never be left in the bathtub for an extended period of time, even if they do not have suction. They should be taken off the tub after each use.

Leaky faucets should be repaired immediately. Water dripping can cause the surface to wear out quickly and leave behind mineral deposits.

You can refinish an old bath tub with these easy maintenance tips. You can refinish bathtubs made from fiberglass or porcelain, as well as the shower enclosures and tile around them. It is important to look for a remodeling company that offers a service warranty to make sure that you get a high-quality product.

Leave a Reply

Your email address will not be published. Required fields are marked *